Fixing Honda Fit's Rear View Camera - Step-by-Step Guide
Table of Contents
- Introduction
- Checking the Fuse Box
- Inspecting the Camera
- Removing the Camera
- Cleaning the Camera
- Replacing the Camera
- Attaching the Harness
- Putting Back the Panel
- Conclusion
- Resources
Introduction
In this article, we will be discussing how to troubleshoot and fix an issue with the rear view camera in a Honda Fit. If you're experiencing a problem with your backup camera not working, we will guide you through step-by-step instructions to identify the cause and resolve the issue. Whether it's a fuse problem, a fogged-up lens, or a faulty camera, we've got you covered. So let's dive in and get your rear view camera back in working order!
Checking the Fuse Box
The first step in diagnosing the issue is to check the fuse box. Locate the fuse box, which is usually situated under the engine bay. Open the box and look for the fuse relating to the backup camera. In most cases, it will be a blue 15 fuse. To check if the fuse is still intact, you can visually inspect it or use a multimeter to test for continuity. If the fuse is blown, replace it with a new one and test if the backup camera starts working.
Inspecting the Camera
If the fuse is not the problem, it's time to move on to the camera itself. Put the vehicle in reverse and observe if the camera signal is reaching the display screen. If the signal is present but there is no picture or if the image is distorted, it may indicate a problem with the camera. In some cases, the lens may be fogged up or contaminated with debris, causing the poor image quality.
Removing the Camera
To inspect and clean the camera, you will need to remove it from the vehicle. Start by removing the panel that covers the camera. This panel may have several clips that can be easily popped open. Once the panel is off, locate the wiring harness connected to the camera. Press the small tab and disconnect the harness. Next, find the clip that holds the camera in place. Push the clip in the direction indicated, either using a screwdriver or your hand, to release the camera.
Cleaning the Camera
With the camera removed, you can now clean both the lens and the lens cover. Use rubbing alcohol and a clean cloth to wipe away any dirt or residue on the lens. Pay special attention to the inside of the camera, where you may find particles that are causing the image distortion. After cleaning, allow the camera to dry before reassembly.
Replacing the Camera
If cleaning the camera does not improve the image quality, it may be necessary to replace the camera. OEM replacements can be quite expensive, but there are affordable aftermarket options available on websites like eBay. Simply purchase a replacement camera, following the specifications of your Honda Fit model. Reverse the process of removing the camera to install the new one, ensuring that the wiring harness is securely connected.
Attaching the Harness
After installing the new camera, attach the wiring harness back to its original position. Make sure to connect the right side first, and then click the left side into place. Double-check that the harness is secure and tightly connected.
Putting Back the Panel
Once the camera and the harness are in place, it's time to put the panel back on. The panel is held in place by multiple clips, which should snap together easily. Carefully align the panel and firmly press it into position until you hear the clips click.
Conclusion
By following the troubleshooting steps outlined in this article, you should be able to identify and resolve issues with your Honda Fit's rear view camera. Whether it's a fuse problem, a fogged-up lens, or a faulty camera, you now have the knowledge to tackle the issue confidently. Remember to always prioritize safety while performing any maintenance or repairs on your vehicle. If you're unsure or uncomfortable with the process, it's best to consult a professional. Good luck with getting your rear view camera back to working condition!
Resources
